Biotrue Multi Purpose Solution 34 Ounces

• How to insert your lenses into your eye:

• 
  Step 1:Wash, rinse, and dry your hands thoroughly. Place the lens on the tip of your pointer finger.
• 
  Step 2:With the same hand, pull your lower eyelid down with your middle finger. With your opposite hand, use your pointer finger to pull your upper eyelid up.
• 
  Step 3:Look up and gently place the lens on the lower white part of your eye.
• 
  Step 4:Close your eye to allow the lens to center.

• How to take them out from your eye:

• 
  Step 1:Wash, rinse, and dry your hands thoroughly. Look up and pull your lower eyelid down with your middle finger.
• 
  Step 2:Put your pointer finger on the lower part of the lens and slide it down onto the white part of your eye.
• 
  Step 3:Gently squeeze the lens with your pointer finger and thumb to remove it.

INDICATIONS (USES): Biotrue multi­-purpose solution
is indicated for use in the daily conditioning, cleaning, removal of protein deposits, rinsing, chemical (not heat) disinfection, and storage of soft (hydrophilic) contact lenses, including silicone hydrogel contact lenses, as recommended by your eye care practitioner.

CONTRAINDICATIONS (REASONS NOT TO USE): If you are allergic to any ingredient in this product, do not use.

ADDITIONAL INFORMATION: Biotrue multi­-purpose solution is not indicated for use with Rigid Gas Permeable (RGP) lenses.

WARNINGS: PROBLEMS WITH CONTACT LENSES AND LENS CARE PRODUCTS COULD RESULT IN CORNEAL INFECTION AND/OR ULCER AND LEAD TO LOSS OF VISION.It is essential that you follow your eye care practitioner’s directions and all labeling instructions for proper use of lenses and lens care products, including the lens case.

• To condition, clean, remove protein and disinfect lenses, complete these simple steps.
• Step 1: Place at least 3 drops of Biotrue multi-purpose solution on each side of lens surface and gently rub for 20 seconds.
  
  Step 2:Thoroughly rinse each side of the lens for 5 seconds with Biotrue multi-purpose solution.
  
  Step 3:Place cleaned contact lenses in the lens case and fill with fresh Biotrue multi-purpose solution. Soak at least 4 hours. Remember to always use fresh solution – discard solution from lens case after each use. Your lenses are now ready to wear.

  
  If any debris remains on contact lenses, rinse with Biotrue multi­-purpose solution prior to insertion.

  Always follow your eye care professional’s instructions. Based upon your individual tear chemistry and lens­ wearing schedule, your eye care professional may recommend additional products or procedures.

  If not wearing contact lenses immediately, store them in a closed lens case. Do not store your lenses in simple saline in place of Biotrue multi­-purpose solution. Saline solution will not disinfect.

  Lenses may be stored in the unopened case until ready to wear, up to a maximum of 30 days. If you store your lenses for longer periods of time, they must be cleaned and disinfected with fresh Biotrue multi­-purpose solution prior to lens insertion.